cafe

Step 2 Take the 4 standoff screws and bolt the chassis to the plate. Step 3 Loosen all top deck screws and bulk head screws and then retighten. Step 4 Remove standoffs and go race!!! 성능은 아니고 뽀대용 같습니다. 출처: http://rcforum.co.kr

and then slightly push the shock rod into the shock body. Excess oil should escape out the top of the shock. Retighten the top collar and retest. Repeat bleeding as required. The shock rod should not be drawn into the shock body when...

2.8 20 Passenger footrest bracket and muffler M10 48 4.8 35 Note: 1. First, tighten the ring nut to approximately 52 Nm (5.2 m-Kg, 38 lb-ft) with a torque wrench 2. Loosen the ring nut completely 3. Retighten the ring nut to specification

Photo 1)DO NOT OVERFILL ... tilt the lantern 15 degrees with cap off, ....if no fuel pours out of it, then you're o.k. Retighten the gauge and the pressure release valve(#13) See photo below 8A. Photo 1 Photo 2 4. Tying or replacing the...

and right bulkheads with the included steel shafts. With the block and pins in place the driver can loosen and retighten both the lower bulkhead mounting screws and also the upper clamps and shock towers for perfect alignment of all...

I have tighten them, and the noise desappear. One month later, the sound come back, the same screw were loosen, retighten them and it's ok. And today the sound come back, I think that i will put some loctite on these 3 screws, they are...

clamps to tighten down: NOTE: Because the clamps are clamping rubber, you should set them snugly, wait an hour, retighten. Repeat as necessary; they'll be hard to get at when in the air! While the pair o' Bills assembled the ESTs to the...

for those who stay within party-defined boundaries, seems to convince China’s leaders that they must tighten and retighten their grip. Increasingly that involves high-technology systems of control, from algorithms that censor social...

x M4x4 Set screws in the mainshaft collar to allow the crown gear hub assembly/mainshaft to move up, don't forget to retighten these afterwards! Servo installation Take extra care when routing the Elevator servo lead so that it can not...